Welcome to eastasiametal. We supply good quality metal with reasonable prices.

    Telephone: +86-21-61212385
    Fax: +86-21-61275188
    Email: sales@eastasiametal.com
    ------------------------------------- Sales Skype:
    EAM skypeEAM-Thomas
    EAM skypeEAM-Echo
    EAM skypeEAM-Monica
    EAM skypeEAM-Bob
    EAM skypeEAM-Anna
    EAM skypeEAM-Tim
    EAM skypeEAM-Jack

    2205 stainless steel plates

    2205 stainless steel plate was used to observe the microstructure of the longitudinal section of the cast specimen with 3 cubits and the hardness was measured. The microstructure analysis showed that most of the primary intermetallic compounds having a melt of 5 were concentrated on the outer peripheral side.
    A composite layer having a thickness of about 810 is formed. The composite layer can be further divided into regions. The outermost peripheral region is a dense and extremely fine human 13 cation phase, and most of them are acicular and dotted linear primary crystals, which are characterized by the longitudinal direction of the crystal grains perpendicular to the centrifugal force direction, and dendritic primary crystals. The area is called a plate-like particle layer.
    The grain is thicker near the inside. It is different from the inner layer of the plate-like particles. A tree structure can be observed on the inner peripheral surface. For the first case where the secondary melt is pure 1, the observation is clear.
    2205 stainless steel plates they make the solution yellow-green in the electrolyte. This is why electropolishing can only be performed after the electrolysis process. The best polishing quality is in the middle stage of the electrolysis process, and the electrocalation solution should remain yellow-green during the production process.

    Get A Quote




    Copyright 2020 All Right Reserved EAM Group
     Phone Number:+86-21-61212385/61212386/61212387/61212388 Contact Mail:sales@eastasiametal.com